Forward Mounting Ultrasonic Sensor for Parking Guidance
Installation height and location of the sensor: installed above (non-rubber catch wheel end) the parking line at the entrance of parking, fixed with the cable tray. The sensor is perpendicular to the tray, as shown as below: (Including explanation of the location and height range, schematic...
Installation height and location of the sensor: installed above (non-rubber catch wheel end) the parking line at the entrance of parking, fixed with the cable tray. The sensor is perpendicular to the tray, as shown as below:
(Including explanation of the location and height range, schematic diagram of installation location and height)
Installation height of the sensor: Z axis direction is 2.0-3.0m (the installation height refers to the one after the sensor is installed away from bottom to the ground, that of the cable tray, height of the sensor: 125mm) away from the ground. The installation height is advised to be 2.2m-2.8m.
Installation location of the sensor: parking middle line at X axis direction (e.g.: the width of parking is 2.4m, and the distance between the middle line and two sides is 1.2m)
Y axis direction is next to the lane side, within 0-0.5m away from the parking line, advised to install it near the parking line.
Corresponding horizontal installation distance of of the installation height is as below: (corresponding best parking dimension is 2.5*5m. the installation location of other parking shall be adjusted according to the actual situation, mainly compared to the location of parking car stop. As for the parking with the length of 5m, the distance between the car stop and parking line is 5-1.1=3.9m. that is, distance between the horizontal installation location of the sensor and car stop shall be 3.9-4.4m. The packing with the length of non-5m can be adjusted according to the method. For actual situation, please consult the related engineer.)
Notes to the installation height
Distance away from the horizontal installation of parking line
Smaller than 0.4m
Smaller than 0.5m
Notes: cannot be installed right under the fluorescent tube; the distance between the horizontal distance and the fluorescent tube is larger than 20cm. However, it should satisfy the requirement that the driver can see the state of the indicator light of the sensor outside 30m along the lane away from the car body and the line of the sight cannot be blocked by such objects as post.
Direction of the sensor after installed: two sensors are opposite to the direction of the parking. The left and right deviation angle should not exceed 5%. there should be no shielding subjects such as post, tray and air hose at the direction that the detection is opposite to when it is guaranteed that the sensor is vertically fixed under the tray.
The installation environment of the sensor: humidity range is 40%~70%RH.
Crosswise parking, can be installed at the side and long side of parking. The distance between the installation distance and the side is 0.2-0.5m. The height is the same as that of the normal installation mode;